A multi-faceted structural, thermodynamic, and spectroscopic approach for investigating ethanol dehydration over

Nicholas A Strange1, Sourav Adak1,2, Zachary Stroupe1

  • 1Department of Chemistry, University of Tennessee, Knoxville, TN 37996, USA. nstrange@slac.stanford.edu.

Related Concept Videos

IR and UV–Vis Spectroscopy of Aldehydes and Ketones01:29

IR and UV–Vis Spectroscopy of Aldehydes and Ketones

Infrared spectroscopy, also known as vibrational spectroscopy, is mainly used to determine the types of bonds and functional groups in molecules. In aldehydes and ketones, the carbonyl (C=O) bond shows an absorption around 1710 cm-1. The C=O bond vibration of an aldehyde occurs at lower frequencies than that of a ketone. In addition to the C=O absorption in an aldehyde, the aldehydic C–H bond also gives two peaks in the 2700–2800 cm-1 range. This absorption, coupled with the...
5.9K
Acid-Catalyzed Dehydration of Alcohols to Alkenes02:35

Acid-Catalyzed Dehydration of Alcohols to Alkenes

In a dehydration reaction, a hydroxyl group in an alcohol is eliminated along with the hydrogen from an adjacent carbon. Here, the products are an alkene and a molecule of water. Dehydration of alcohols is generally achieved by heating in the presence of an acid catalyst. While the dehydration of primary alcohols requires high temperatures and acid concentrations, secondary and tertiary alcohols can lose a water molecule under relatively mild conditions.
20.6K
Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis02:29

Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis

Overview
Ethers can be prepared from organic compounds by various methods. Some of them are discussed below,
Preparation of Ethers by Alcohol Dehydration
In this method, in the presence of protic acids, alcohol dehydrates to produce alkenes and ethers under different conditions. For example, in the presence of sulphuric acid, dehydration of ethanol at 413 K yields ethoxyethane, whereas it yields ethene at 443 K.
10.8K
Aldehydes and Ketones with Water: Hydrate Formation01:20

Aldehydes and Ketones with Water: Hydrate Formation

An oxygen-based nucleophile, like water, can undergo addition reactions with aldehydes and ketones. The reaction leads to the formation of hydrates, also referred to as 1,1-diols or geminal diols.
The formation of hydrates is a reversible reaction. Hydrate formation is influenced by steric and electronic factors accompanying the alkyl substituents on the carbonyl group: The rate of hydrate formation increases with a decrease in the number of alkyl groups attached to the carbonyl carbon. Hence,...
3.4K
NMR Spectroscopy and Mass Spectrometry of Aldehydes and Ketones01:15

NMR Spectroscopy and Mass Spectrometry of Aldehydes and Ketones

In aldehydes, the hydrogen atom connected to the carbonyl carbon helps distinguish aldehydes from other carbonyl compounds using ¹H NMR spectroscopy. The closeness of aldehydic hydrogen to the electrophilic carbonyl carbon highly deshields the hydrogen atom causing its signal to appear around 10 ppm in the ¹H NMR spectra. α hydrogens split the aldehydic proton signal, which helps identify the number of α hydrogens in the molecule. For instance, one α hydrogen creates a...
4.3K
Dehydration of Aldols to Enals: Base-Catalyzed Aldol Condensation01:14

Dehydration of Aldols to Enals: Base-Catalyzed Aldol Condensation

This lesson delves into the aldol condensation catalyzed by bases, where aldols undergo dehydration to enals. As shown in Figure 1, the β-hydroxy aldehyde formed in a base-catalyzed aldol addition reaction dehydrates on heating to yield an unsaturated carbonyl product, which is commonly referred to as an enal.
5.7K