Related Experiment Video
Updated: Aug 17, 2025
Scalable Step-by-Step Approach of Sustainable Bioplastic Production from Food Waste
Published on: July 18, 2025
Composition, Properties, and Utilization of Fumaric Acid Sludge By-Produced from Industrial Phthalic Anhydride
Zhongjin Wei1, Fengshan Zhou1, Sinan Chen1,2
1Beijing Key Laboratory of Materials Utilization of Nonmetallic Minerals and Solid Wastes, National Laboratory of Mineral Materials, School of Materials Science and Technology, China University of Geosciences (Beijing), Beijing 100083, China.
Abstract:
To understand fumaric acid sludge (FAS) systematically and comprehensively and find out how to utilize it, we conducted a series of characterization analyses on FAS. Fourier transform infrared (FT-IR) Spectra shows that the main component of FAS is fumaric acids and also contains a small amount of silicate. The nuclear magnetic resonance hydrogen (1H-NMR) spectrum also shows that fumaric acid accounted for a large proportion of FAS. The X-ray diffraction (XRD) shows that the main phase in FAS is fumaric acid, and there is also a small amount of Kaliophilite. After gas chromatography and mass spectrometry (GC-MS) and pyrolysis gas chromatography and mass spectrometry (Py-GC-MS) analysis, it indicates that the possible volatiles and pyrolysis products in FAS are fumaric acid, maleic acid, maleic anhydride, phthalic acid, etc. In the test of Liquid chromatography and mass spectrometry (LC-MS), we determined the contents of phthalic acid, fumaric acid, and maleic acid in FAS. The detailed mass content of each component in FAS is as follows: phthalic acid is about 0.10-0.15%; maleic anhydride is about 0.40-0.80%; maleic acid is about 18.40-19.0%; fumaric acid is about 55.00-56.90%; succinic anhydride is about 0.06-0.08%; acrylic acid is about 0.06-0.08%; malic acid is about 0.90-1.00%; acetic acid is about 0.10-0.20%; silicate is about 0.25-0.30%; phthalic anhydride is about 0.20-0.30%; water is about 24.30-24.80%. The filtrate loss reducer (PAAF) used in oilwell drilling fluids synthesized by FAS not only has excellent temperature and complex saline resistance, the API filtration loss (FL) was only 13.2 mL/30 min in the complex saline based mud, but is also cost-effective.
More Related Videos
Related Concept Videos
01:20Fates of Pyruvate
In aerobic organisms, pyruvate is metabolized via the citric acid cycle to produce reduced coenzymes NADH and FADH2. These coenzymes are then oxidized in the electron transport chain to produce ATP and, in the process, regenerate the NAD+ and FAD. As seen in some cell types and organisms, fermentation...
01:07Preparation of Acid Anhydrides
The carboxylate ion acts as a nucleophile that attacks the carbonyl carbon of the acid chloride to form a tetrahedral intermediate. Subsequently, the re-formation of the carbonyl group with the loss of the chloride ion as a leaving group leads to the formation of an acid...
04:01Factors Affecting Solubility
01:25Lipid Catabolism
01:20Types of Step-Growth Polymers: Polyesters
Polyesters are commonly prepared from terephthalic acid and ethylene glycol; the crude product is known as poly(ethylene terephthalate) or PET. However, polyesters are synthesized industrially by transesterification of dimethyl terephthalate with ethylene glycol at 150 °C. The two reactants and the...
01:01Acid Halides to Carboxylic Acids: Hydrolysis
As shown below, the mechanism involves a nucleophilic attack by water at the carbonyl carbon to form a tetrahedral intermediate. This is followed by the reformation of the carbon–oxygen π bond along with the departure of a halide ion. A final proton transfer step yields carboxylic...