Hydrodynamic Analysis and Cake Erosion Properties of a Modified Water-Based Drilling Fluid by a Polyacrylamide/Silica...

In this study, the potential of using a polyacrylamide-silica nanocomposite (PAM-S) to control the filtration properties of bentonite water-based drilling muds under different salinity conditions was evaluated. Static filtration tests under low-pressure/low-temperature (LPLT) conditions accompanied by rheological measurements have been carried out to analyze the role of silica nanoparticles (NPs) and nanocomposites (NCs) in the base fluid properties. Moreover, high-pressure/high-temperature (HPHT) static filtration was also investigated to evaluate the thermal stability of PAM-S. Afterward, dynamic filtration has been conducted in a filtration cell equipped with an agitating system with a disk-type impeller to investigate the hydrodynamic and formation of a filter cake under shear flow conditions. Fluid flow velocity and wall shear stress (WSS) distribution over the filter cake were analyzed using an exact 3D computational fluid dynamic (CFD) simulation. A transparent filtration cell with a camera was used to accurately record the fluid flow field inside the filter press and validate the CFD results. The obtained results indicated that adding silica NPs at a concentration of less than 2 wt % increases the fluid loss due to reducing rheological properties such as yield point. While silica NPs could not significantly change the mud properties, the experimental results showed that, under both LPLT and HPHT conditions, the PAM-S NC could reduce the total filtration loss by 70% at a low concentration of 0.75 wt %. Moreover, during dynamic filtration, the results indicated that there is a linear relationship between the cake thickness and the inverse of WSS at different operating pressures. However, no correlation could be found between predeposited mud cake erosion and WSS. At a rotating disk speed of 1000 rpm, more than 60% of the predeposited mud cake was eroded after 30 min for a saline mud sample while for the NC-treated mud sample cake erosion is considerably reduced and reaches up to 20% at 1.5 wt % PAM-S.