Heterogeneity and lyophilization comparison of stool processing for gastrointestinal bile acid measurement by...

Fecal bile acid (BA) analysis is an emerging area of gut microbiome research. However, sample preparation procedures for fecal BA analysis are not standardized. Current fecal BA analysis often utilizes either original or lyophilized aliquot, and fecal BA result difference between these two processing steps remains not systematically investigated. Moreover, the distribution pattern of fecal BA in the collected stool sample also remains unclear but affects interpretation of fecal BA for downstream experiments. To address these two questions regarding effect of lyophilization on fecal BA and fecal heterogeneity, fourteen separate BAs were quantified from 60 aliquots obtained from 10 clinical fecal samples using liquid chromatography-tandem mass spectrometry (LC-MS/MS). BA concentrations in the lyophilized sample were typically 2-4 folds higher than those in the original sample, but were almost identical using a water-adjusted lyophilized BA concentration. The fecal BA compositional profile and four BA ratios were similar utilizing either the original or lyophilized samples. BA concentrations were similar among different aliquots of differing starting mass except for the relatively trace-level BA. Therefore, it is suggested that fecal BA concentrations should be presented as the original sample concentration or water-adjusted lyophilization concentration to allow comparisons between studies. A single aliquot (20-100 mg) of stool can be used to reflect the concentrations in the entire sample. These results help to standardize analyses in this emerging field.