Related Experiment Video
Updated: Aug 17, 2025

Characterization and Application of Passive Samplers for Monitoring of Pesticides in Water
Published on: August 3, 2016
A non-target screening study of high-density polyethylene pipes revealed rubber compounds as main contaminant in a
Tomas Diera1, Anne Holm Thomsen2, Selina Tisler1
1Analytical Chemistry Group, Department of Plant and Environmental Science, Faculty of Science, University of Copenhagen, Thorvaldsensvej 40, 1871 Frederiksberg, Denmark.
Abstract:
Polyethylene (PE) pipes are often the material of choice for water supply systems, thanks to their favorable properties, such as high strength-density ratio and corrosion resistance. However, previous studies have shown that organic compounds can migrate from PE pipes to the water. This study aimed to identify potential organic compounds migrating from high-density PE (HDPE) pipes used to distribute drinking water in Denmark, based on laboratory experiments and sampling in the distribution system using a two-tiered study design. In the first tier, migration of volatile and semi-volatile organic compounds (VOCs and semi-VOCs) from HDPE pipes were investigated over one, three, and nine days in laboratory experiments, performed according to modified standards for migration testing (EN 12,873-1). The analytical workflow consisted of solid-phase extraction (SPE) for 10,000 times enrichment and gas chromatography - mass spectrometry (GC-MS) analysis from the water phase after migration. A total of 133 compounds originating from the PE pipes were detected. Thirty-one compounds were detected by suspect screening (SS), while the remaining 102 compounds were detected by non-target screening (NTS) analysis. Among the detected compounds were also hindered amine stabilizers (HALS), flame retardant, and plasticizer tris(2-chloroethyl) phosphate. In the second tier, drinking water from a water distribution system in Copenhagen, Denmark, with a newly installed HDPE pipe was sampled and analyzed with GC-MS and liquid chromatography high-resolution mass spectrometry (LCHRMS). A total of 51 compounds were detected in the water, 12 of which were assigned to migration from HDPE. Surprisingly, HDPE antioxidants and their degradation products contributed only a relatively small percentage of the total measured compound intensities in the drinking water distribution system. Instead, a larger proportion of the compounds detected were assigned to rubber seals, used upstream in the water system from the abstraction site to delivery at the consumer tap. Seals are considered trifle in the larger picture of materials in contact with drinking water, however these results may cause a reconsideration of this position.
More Related Videos
08:00Screening for Endocrine Activity in Water Using Commercially-available In Vitro Transactivation Bioassays
Published on: December 4, 2016
11:19Preparation and Testing of Impedance-based Fluidic Biochips with RTgill-W1 Cells for Rapid Evaluation of Drinking Water Samples for Toxicity
Published on: March 7, 2016
Related Concept Videos
Free-Radical Chain Reaction and Polymerization of Alkenes
Polymer Classification: Architecture