Related Experiment Video

Updated: Aug 17, 2025

Proximal Cadaveric Femur Preparation for Fracture Strength Testing and Quantitative CT-based Finite Element Analysis
08:04

Proximal Cadaveric Femur Preparation for Fracture Strength Testing and Quantitative CT-based Finite Element Analysis

Published on: March 11, 2017

9.4K

Structure-mechanical analysis of various fixation constructs for basicervical fractures of the proximal femur and

Joon-Woo Kim1, Chang-Wug Oh1, Beom-Soo Kim2

  • 1Department of Orthopaedic surgery, School of Medicine, Kyungpook National University, Kyungpook National University Hospital, 130 Dongduk-ro, Jung-gu, Daegu 41944, Republic of Korea.

Injury
|December 18, 2022
PubMed
Abstract

Keywords:
Basicervical fractureFinite element analysisInternal fixationProximal femur

More Related Videos

Method and Instrumented Fixture for Femoral Fracture Testing in a Sideways Fall-on-the-Hip Position06:58

Method and Instrumented Fixture for Femoral Fracture Testing in a Sideways Fall-on-the-Hip Position

Published on: August 17, 2017

10.1K
A Method to Estimate Cadaveric Femur Cortical Strains During Fracture Testing Using Digital Image Correlation09:34

A Method to Estimate Cadaveric Femur Cortical Strains During Fracture Testing Using Digital Image Correlation

Published on: September 14, 2017

7.5K

Related Concept Videos

Bending of Members Made of Several Materials01:08

Bending of Members Made of Several Materials

In analyzing a structural member composed of two different materials with identical cross-sectional areas, it is crucial to understand how their distinct elastic properties affect the member's response under load. The analysis involves assessing stress and strain distributions using the transformed section concept, which accounts for variations in material properties.
Hooke's Law determines stress in each material, stating that stress is proportional to strain but varies due to each...
247
Frames: Problem Solving II01:26

Frames: Problem Solving II

Consider a hydraulic hoist supporting a load of 1 kN. Assuming a simplified schematic representation of this frame structure, the force acting on BD and BF members can be determined.
272
Indeterminate Structure01:18

Indeterminate Structure

Indeterminate structures refer to structures where internal forces and reactions cannot be determined using only the equations of static equilibrium.  Indeterminate structures have more unknown forces and reaction forces than equations of static equilibrium that can be used to determine them. Indeterminate structures are often used in engineering to create complex, efficient, and aesthetically pleasing structures. There are various types of indeterminate structures used in engineering and...
897
Stability of structures01:14

Stability of structures

In mechanical engineering, the stability of systems under various forces is critical for designing durable and efficient structures. One fundamental way to explore these concepts is by analyzing systems like two rods connected at a pivot point, O, with a torsional spring of spring constant k at the pivot point. This system is similar in appearance to a scissor jack used to change tires on a car. In this case, the arms of the linkage (equivalent to the rods in this system) are entirely vertical,...
221
Method of Joints: Problem Solving I01:30

Method of Joints: Problem Solving I

The method of joints is a commonly used technique to analyze the forces in structural trusses. The method is based on the principle of equilibrium, which assumes that the truss members are connected by frictionless pins. The forces at each joint can be determined by considering the equilibrium of the forces acting on that joint. Consider a truss structure with two forces of 20 N and 10 N acting at joints C and D, respectively. The method of joints can be used to determine the forces FCB, FDC,...
1.2K
Method of Sections01:30

Method of Sections

Consider a truss structure, as shown in the figure.
738