Related Experiment Video
Updated: Aug 16, 2025

An Inertial Measurement Unit Based Method to Estimate Hip and Knee Joint Kinematics in Team Sport Athletes on the Field
Published on: May 26, 2020
Investigating External and Internal Loads in Male Older Adult Basketball Players during Official Games
Daniele Conte1,2, Federico Palumbo2, Flavia Guidotti2
1Institute of Sport Science and Innovations, Lithuanian Sports University, 44221 Kaunas, Lithuania.
Abstract:
This study aimed at assessing the external [Player Load (PL), acceleration (ACC), changes of direction (COD), JUMP, and their relative values (PL/min; ACC/min; COD/min and JUMP/min)] and internal [percentage of the peak heart rate (%HRpeak) and the training load calculated with the session rating of perceived exertion (sRPE) method (sRPE-load)] loads of masters (senior citizen) basketball players during official games. Thirteen male basketball masters players (age: 66.6 ± 2.1 years; body mass: 89.9 ± 8.7 kg; stature: 183.7 ± 4.6 cm) were monitored during an official Lietuvos Krepsinio Veteranu Lyga (LKVL) 65-year game. Beside descriptive analysis, a chi-square goodness of fit test was adopted to assess the differences in the distribution within JUMP, ACC and COD classes of intensities (i.e., low, medium and high). The results revealed PL = 269.9 ± 83.3 AU and PL/min = 6.54 ± 1.29 AU/min. Moreover, significant differences (p < 0.001) in the distribution of the intensity classes were found for JUMP, ACC, and COD, with the lowest intensities as the most frequent. Finally, HRpeak = 81.7 ± 8.1% and sRPE-load = 148.9 ± 69.7 AU were found, with sRPE = ~3 AU. In conclusion, a low external load during an official basketball game was found compared to other basketball populations. Moreover, a high objective internal load did not correspond to a low perceived demand, which might increase the training adherence and motivation during long-term studies.
Related Concept Videos
Social Facilitation
Stresses under Combined Loadings
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
Internal Loadings in Structural Members: Problem Solving
To illustrate this, let's consider a beam OC of 5 kN, inclined at an angle of 53.13° with the horizontal and supported at both ends. Determine the internal...
Indeterminate Structure
Internal and External Forces
General Case of Eccentric Axial Loading
Consider a member subjected to equal and opposite forces that are applied along a line that does not coincide with the member's neutral axis. In unsymmetrical...

