Related Experiment Video
Updated: Aug 16, 2025
Facile and Efficient Preparation of Tri-component Fluorescent Glycopolymers via RAFT-controlled Polymerization
Published on: June 19, 2015
Preparation of an Antioxidant Assembly Based on a Copolymacrolactone Structure and Erythritol following an
Aurica P Chiriac1, Alina Ghilan1, Alexandru-Mihail Serban1
1Petru Poni Institute of Macromolecular Chemistry, 41 A Grigore Ghica Voda Alley, 700487 Iasi, Romania.
Abstract:
The study presents the achievement of a new assembly with antioxidant behaviour based on a copolymacrolactone structure that encapsulates erythritol (Eryt). Poly(ethylene brassylate-co-squaric acid) (PEBSA) was synthesised in environmentally friendly conditions, respectively, through a process in suspension in water by opening the cycle of ethylene brassylate macrolactone, followed by condensation with squaric acid. The compound synthesised in suspension was characterised by comparison with the polymer obtained by polymerisation in solution. The investigations revealed that, with the exception of the molecular masses, the compounds generated by the two synthetic procedures present similar properties, including good thermal stability, with a Tpeak of 456 °C, and the capacity for network formation. In addition, the investigation by dynamic light scattering techniques evidenced a mean diameter for PEBSA particles of around 596 nm and a zeta potential of -25 mV, which attests to their stability. The bio-based copolymacrolactone was used as a matrix for erythritol encapsulation. The new PEBSA-Eryt compound presented an increased sorption/desorption process, compared with the PEBSA matrix, and a crystalline morphology confirmed by X-ray diffraction analysis. The bioactive compound was also characterised in terms of its biocompatibility and antioxidant behaviour.
Related Concept Videos
01:57Preparation of Diols and Pinacol Rearrangement
The reaction begins with transferring a proton from the acid catalyst to one of the hydroxyl groups, producing an oxonium ion.
03:00Preparation of Epoxides
Epoxides result from alkene oxidation, which can be achieved by a) air, b) peroxy acids, c) hypochlorous acids, and d) halohydrin cyclization.
Epoxidation with Peroxy Acids
Epoxidation of alkenes via oxidation with peroxy acids involves the conversion of a carbon–carbon double bond to an epoxide using the oxidizing agent meta-chloroperoxybenzoic acid, commonly known as MCPBA. Since the O–O bond of peroxy acids is very weak, the addition of electrophilic oxygen of...
01:38Preparation of Alcohols via Substitution Reactions
Alcohols can be synthesized from alkyl halides via nucleophilic substitution reactions. The highly polar carbon-halogen bond in the substrate makes halide a good leaving group. The hydroxide ion or water can act as a nucleophile to take the place of halide and form an alcohol. The substitution reactions occur via two different reaction pathways, SN1 or SN2, depending on the nature of carbon attached to the halide.
Primary alcohols are synthesized from primary alkyl halides, and the...
01:33Preparation of Aldehydes and Ketones from Alcohols, Alkenes, and Alkynes
01:18Preparation of Aldehydes and Ketones from Carboxylic Acid Derivatives
Carboxylic acid derivatives like acid chlorides and esters are more easily reducible than the corresponding acids. The derivatives reduce in the presence of mild reducing agents to give aldehydes. Aldehydes can also be prepared by Rosenmund reduction, that is, the reduction of...