Related Experiment Video
Updated: Aug 16, 2025

Production and Analysis of Sporosarcina pasteurii Biocement Bricks Using Custom 3D-Printed Molds for Unconfined Compression Tests
Published on: March 7, 2025
Mechanical Strength and Thermal Properties of Cement Concrete Containing Waste Materials as Substitutes for Fine
Paweł Łukowski1, Elżbieta Horszczaruk2, Cyprian Seul2
1Department of Building Materials Engineering, Faculty of Civil Engineering, Warsaw University of Technology, 00-637 Warsaw, Poland.
Abstract:
The increasing volume of waste and the requirements of sustainable development are the reasons for the research on new waste management concepts. The research results presented in this paper show the effect of recycled aggregate on the selected properties of cement concrete. The aggregates obtained from three types of wastes are tested: recycled concrete paving, crushed ceramic bricks, and burnt sewage sludges. The recycled aggregates replaced 25% and 50% of the volume of the fine aggregate. The tested aggregates worsen the concrete mixes' consistency and decrease, to some extent, the compressive strength of the concrete. However, the tensile splitting strength of the concrete with recycled aggregates is similar to that of the reference concrete. Using recycled aggregates worsens the tightness of the concrete, which manifests itself by increasing water penetration depth. The thermal properties of concrete are slightly affected by the type and content of the recycled aggregate. Considering the expected improvement in recycled aggregate processing, they can be an alternative to natural aggregates. Using recycled aggregates in cement concrete requires extensive studies to search for ways to increase their possible content without worsening concrete performance.
Related Concept Videos
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Deleterious Substances in Aggregate
Another type of impurity is clay and fine material that...
Bonding and Strength of Aggregate
Aggregate Cement Ratio
Additives and Fillers in Concrete
The...
Types of Cement I
Type I (Ordinary Portland Cement) is widely used for general construction where special properties are not required. It has moderate sulfate resistance and heat of hydration.
Type II (Modified Cement) offers moderate resistance to sulfate attack and a lower rate of heat development compared to Type I. It is suitable for structures in...

