Effect of Paste Fluidity and Paste-to-Aggregate Ratio on the Strength and Permeability of Porous Mortar from...

Many places in the world suffer from a shortage of river sand because of population growth and environmental protection, and people have to replace river sand with manufactured sand (M-sand). In this study, M-sand was adopted as aggregate and the effect of the mix design (paste fluidity (PF) and paste-to-aggregate ratio (P/A)) on the properties of porous mortar was investigated through a combined experimental, statistical and response surface method (RSM). By including variations in both P/A (0.16-0.26) and PF (160-200 mm), the method was utilized to develop ANOVA models and construct response surface and contour lines. The experimental results revealed that the compressive strength of the porous mortar increased by 62.3% to a value of 34.1 MPa while the PF increased to 190 mm from 160 mm at a P/A of 0.20, and the water permeability coefficient was 7.2 mm/s under the same conditions. In addition, the ANOVA analysis of the measured properties revealed a strong interactive effect of the paste-to-aggregate ratio and paste fluidity on the porous mortar properties, and the developed relationship models between the variables and responses were accurate. A porous mortar with a compressive strength over 30 MPa and a permeability coefficient over 7 mm/s could be conveniently designed by RSM. Additionally, the compressive strength of the porous concrete reached more than 40 MPa at a P/A of 0.26.