Related Experiment Video
Updated: Aug 15, 2025

Continuously-stirred Anaerobic Digester to Convert Organic Wastes into Biogas: System Setup and Basic Operation
Published on: July 13, 2012
Effect of the initial pH on the anaerobic digestion process of dairy cattle manure
Job Jonathan Castro-Ramos1, Aida Solís-Oba2, Myrna Solís-Oba3
1Instituto Politécnico Nacional, Centro de Investigación en Biotecnologia Aplicada, 90700, Tepetitla de Lardizábal, Tlaxcala, Mexico.
Abstract:
Anaerobic digestion (AD) has recently been studied to obtain products of greater interest than biogas, such as volatile fatty acids (VFAs) and phytoregulators. The effect of the initial pH of cow manure and the fermentation time of the AD on the microbial composition, VFAs, indole-3-acetic acid (IAA) and gibberellic acid (GA3) production was evaluated. The cow manure (7% solids) was adjusted to initial pH values of 5.5, 6.5, 7.5, and 8.5, and the AD products were analyzed every four days until day 20. The initial pH and the fermentation time had an important effect on the production of metabolites. During AD, only the hydrolytic and acidogenic stages were identified, and the bacteria found were from the phyla Firmicutes, Bacteroidetes, Actinobacteria, and Spirochaetes. The most abundant genera produced in the four AD were Caproiciproducens, Clostridium sensu stricto 1, Romboutsia, Paeniclostridium, Turicibacter, Peptostreptococcaceae, Ruminococcaceae and Fonticella. The highest amount of VFAs was obtained at pH 8.5, and the production of the acids was butyric > acetic > propionic. The maximum production of GA3 and IAA was at an initial pH of 6.5 on day 20 and a pH of 5.5 on day 4, respectively. There was a strong correlation (> 0.8) between the most abundant microorganisms and the production of VFAs and GA3. The anaerobic digestion of cow manure is a good alternative for the production of VFAs, GA3 and IAA.
Related Concept Videos
Factors Influencing Microbial Growth: pH
Titration of a Weak Base with a Strong Acid
Using the ICE table and substituting the Kb value, we calculate the initial pH of 50 mL of 0.1 M ammonia to be 11.11. Addition of 25 mL of 0.1 M hydrochloric acid to this solution of ammonia results in a buffer with an equal concentration of ammonia and ammonium ions. The pH of this buffer can be calculated by substituting these...
Titration of a Weak Acid with a Weak Base
As a result, there is no simple...
Titration of a Strong Acid with a Strong Base
Titration of a Weak Acid with a Strong Base
Common Ion Effect

