Experimental study on the redistribution law of heavy metals in sludge disintegration

Aiming at the problems of large output of excess sludge, difficulty in treatment and disposal, and the potential toxicity of heavy metals restricting its resource utilization, this paper studies the redistribution law of heavy metals in the process of sludge disintegration. The dissertation investigates the distribution law of typical heavy metals such as Cu, Pb, Cd, Zn in the process of microwave and citric acid-microwave cracking sludge under different specific energy and fixed specific energy conditions. The Tessier five-step continuous extraction method was used to extract heavy metals, and the changes in their content and chemical forms were analyzed, which provided certain technical support for the subsequent harmless treatment and resource utilization of excess sludge. The main findings of this paper are as follows: The dissolution rate of heavy metals Cu, Pb, Cd, and Zn increased rapidly during the citric acid-microwave cracking process in the TS specific energy range of 0-45000 kJ/kg, and then gradually tended to be gradual. The maximum dissolution rates of Cu, Pb, Cd, Zn were 8.06%, 16.58%, 14.69%, and 24.11%, respectively. The concentrations of Cu, Pb, Cd, and Zn in the sludge were mainly F4; F3, F4; F2, F3. The proportions of stable states of Cu, Pb, Cd, and Zn in sludge increased to 88.6%, 55.91%, 35.7%, and 31.35%, respectively. When the specific energy was 45000 kJ/kg TS, the concentrations of Pb, Zn, and Cd in the solid phase of the sludge appeared to increase under microwave cracking alone and decrease under the combined action of citric acid and microwave. The concentration of Cu in the solid phase of the sludge increased slightly. The dissolution rates of Pb, Cd, and Zn by microwave alone and citric acid-microwave method were 14.23% and 16.58%, 10.34% and 14.69%, 17.53%, and 24.11%, respectively. The dissolution rates of Cu by both methods were lower. The steady state ratios of Pb and Zn in the citric acid-microwave method increased to 55.91% and 31.25%, respectively; the steady state ratio of Cd in the microwave alone method increased to 39.51%; both methods had no significant effect on the stability of Cu.