Potential and kinetic energy of underwater noise measured below a passing ship and response to sub-bottom layering

Observed near the seafloor, broadband noise emissions from a vessel passing directly above exhibit frequency bands where potential acoustic energy is greater than kinetic energy while the opposite occurs in neighboring frequency bands. The condition where the dynamic and kinematic energy forms differ in this manner is characteristic to interference involving steep angles or near-normal incidence reflection from the seafloor. Measurements are made at two experimental sites using a research vessel passing above a vector sensor, positioned ∼1.5 m above the seabed, resulting in a vessel horizontal range approaching ∼0. The data are expressed as a ratio of kinetic to potential energy in decibels and yield information on seabed properties. A model for kinetic and potential energy is developed from the method of images using a layered seabed and is used to invert data collected in Puget Sound. A higher-impedance seabed is identified via inversion, which is consistent with the thin Holocene sediments in the region. For data collected on the New England Mud Patch, the model is instead applied directly to nominal seabed parameters originating from prior studies that identify a low-speed mud layer atop a higher-speed transition layer separating the mud substrate from a sediment basement.