Effects of Sonication and Thermal Pasteurization on the Nutritional, Antioxidant, and Microbial Properties of Noni

Yi Xuan Choo1, Lai Kuan Teh1, Chin Xuan Tan1

  • 1Department of Allied Health Sciences, Faculty of Science, Universiti Tunku Abdul Rahman, Kampar Campus, Kampar 31900, Perak, Malaysia.

Related Concept Videos

Physical Methods for Controlling Microbial Growth: Temperature01:23

Physical Methods for Controlling Microbial Growth: Temperature

Heat is a widely used method to control microbial growth by targeting and denaturing cellular proteins, thereby killing or inactivating microbes. This method's effectiveness is quantified using parameters such as the thermal death point (TDP), thermal death time (TDT), and decimal reduction time (D value). TDP represents the lowest temperature at which all microorganisms in a liquid suspension are eliminated within 10 minutes, whereas TDT is the time necessary to achieve sterilization at a...
176
Physical Methods for Controlling Microbial Growth: Radiation and Filtration01:26

Physical Methods for Controlling Microbial Growth: Radiation and Filtration

Radiation and filtration are essential tools for microbial control, targeting microorganisms through distinct mechanisms. Radiation eliminates microbes by damaging their DNA, either killing them or inhibiting their growth. Based on wavelength, radiation is classified into two types: nonionizing and ionizing radiation.Non-ionizing radiation, such as UV radiation (200–400 nm), is absorbed by DNA, causing defects that effectively disinfect surfaces, air, and water, including safety cabinets.
175
Extraction: Effects of pH00:53

Extraction: Effects of pH

Consider a neutral form of an amine, B, with a partition coefficient, K, in a liquid mixture containing organic and aqueous phases. The pH of the aqueous phase affects the charge on acidic and basic solutes, and the charged form is usually more soluble in the aqueous phase. Suppose the conjugate acid form of the amine is soluble only in the aqueous phase while the base form is soluble in both phases. Then the distribution coefficient, D, can be given as the ratio of amine concentration in the...
574
Physical Properties Affecting Solubility02:19

Physical Properties Affecting Solubility

Solutions of Gases in Liquids
As for any solution, the solubility of a gas in a liquid is affected by the attractive intermolecular forces between solute and solvent species. Unlike solid and liquid solutes, however, there is no solute-solute intermolecular attraction to overcome when a gaseous solute dissolves in a liquid solvent since the atoms or molecules comprising a gas are far separated and experience negligible interactions. Consequently, solute-solvent interactions are the sole...
22.8K
Factors Affecting Dissolution: Drug Permeability, Stability and Stereochemistry01:20

Factors Affecting Dissolution: Drug Permeability, Stability and Stereochemistry

Orally administered drugs primarily enter the systemic circulation via passive diffusion through the intestinal membranes. The drug's absorption is influenced by drug stability in the gastrointestinal GI tract, membrane permeability, the surface area available for absorption, luminal drug concentration, and residence time in the lumen. Drug permeability can be enhanced by adjusting the lipophilicity, polarity, or molecular size of the drug, promoting its passive transport across intestinal...
244
Tissue Homogenization and Cell Lysis01:32

Tissue Homogenization and Cell Lysis

Tissue homogenization involves disintegrating tissue architecture and lysing cells, and is an early step in isolating and analyzing cellular components. The method used for homogenization depends on the sample type, the amount of sample available, the analyte to be obtained, and the sensitivity of the method. These methods are broadly classified as mechanical and non-mechanical methods.
Mechanical methods of tissue homogenization
These methods rely on applying external physical force to disrupt...
7.8K