Preparation of phosphogypsum-copper smelting slag-based consolidating body with high compressive strength

Phosphogypsum (PG) is an industrial waste residue produced during the production of phosphoric acid through the wet process. With strong acidity and a large amount of toxic impurities, PG is difficult to reuse. In this study, the solidified body (PG-S) was made by mechanical compression of the mixture of PG, copper smelting slag (CSS), CaO, NaOH, and water. Results indicate that the composition of the material phases in the PG-S samples changed with hydrated calcium silicate and amorphous silicate derivatives were formed during the reaction; Fe and Ca in the material were transformed; and the prepared geopolymer material had a dense internal structure with the materials being cemented to each other. The highest compressive strength of PG-S cured for 28 days could reach 21.3 MPa with a fixation efficiency of PO₄^3-and F^-reaching 99.81 and 94.10%, respectively. The leaching concentration of heavy metals of the PG-S cured for 28 days met the requirements of the Comprehensive Wastewater Discharge Standard (GB 8978-1996). The simulation results of the geochemical model verified the feasibility of the whole immobilization process from the thermodynamic point of view. This work directly uses copper smelting slag and phosphogypsum for coupled immobilization/stabilization treatment not only to achieve the immobilization of pollutants in both solid wastes but also to obtain colloidal masses with certain compressive strength, which also provides a new option for resource utilization of phosphogypsum and copper smelting slag. This work also shows great potential in turning the actual mine backfill into cementitious material.