Related Experiment Video
Updated: Jun 28, 2026
Imine Metathesis by Silica-Supported Catalysts Using the Methodology of Surface Organometallic Chemistry
Published on: October 18, 2019
Iron(III) Arylhydrazone Complexes Immobilized on Amine-Functionalized Mesoporous Silica: Catalysts for the
Mohamed M A Soliman1,2, Carlos M Granadeiro3, Salete S Balula3
1Centro de Química Estrutural, Departamento de Engenharia Química, Instituto Superior Técnico, Universidade de Lisboa, Av. Rovisco Pais, 1049-001, Lisboa, Portugal.
Abstract:
The aquasoluble FeIII complexes [Fe(H2 O)3 (L1 )] ⋅ 4H2 O (Fe1) and [Fe(H2 O)3 (L2 )] ⋅ 3H2 O (Fe2), bearing the basic forms of 5-chloro-3-(2-(4,4-dimethyl-2,6-dioxocyclohexylidene)hydrazinyl)-2-hydroxy-benzenesulfonic acid (H3 L1 ) and 3-(2-(2,4-dioxopentan-3-ylidene)hydrazinyl)-2-hydroxy-5-nitrobenzenesulfonic acid (H3 L2 ), were incorporated for the first time into amine-functionalized SBA-15 support via an impregnation method. The successful preparation of the composites was confirmed by Fourier-Transform Infrared spectroscopy (FT-IR), powder X-ray diffraction (XRD), scanning electron microscope (SEM/EDS), transmission electron microscopy (TEM), elemental analysis, and nitrogen adsorption-desorption isotherms. The resulting Fe1@aptesSBA-15 and Fe2@aptesSBA-15 composites were tested as the first SBA-15-based heterogeneous catalysts for the conversion of furfuryl alcohol under mild reaction conditions (80 to 100 °C) and with an environmentally friendly oxidant (TBHP, 70 % aq. sol. with 1 : 1 oxidant/substrate molar ratio). The influence of various factors, such as reaction time, amounts of oxidant and catalyst, was investigated. The reaction time can be fairly reduced by adopting a microwave-assisted method allowing it to reach complete conversion after 0.25 h, in the absence of any added solvent or additive. Under these conditions, a vigorous furfuryl alcohol polymerization process occurred, with furfural as a by-product. Recycling studies were carried out for Fe2@aptesSBA-15 and after four consecutive runs, the overall conversion of furfuryl alcohol remained high (≥99 %), without an appreciable change in the obtained yield.
More Related Videos
12:08Catalytic Reactions at Amine-Stabilized and Ligand-Free Platinum Nanoparticles Supported on Titania During Hydrogenation of Alkenes and Aldehydes
Published on: June 24, 2022
08:00Author Spotlight: Standardizing the Development of Amine-Based Silica Composites as CO2 Adsorbents for Direct Air Capture
Published on: September 29, 2023
Related Concept Videos
02:17Reduction of Alkenes: Asymmetric Catalytic Hydrogenation
The metal catalyst used can be either heterogeneous or homogeneous. When hydrogenation of an alkene generates a chiral center, a pair of enantiomeric products is expected to form. However, an enantiomeric excess of one of the products can be facilitated using an enantioselective reaction or an...
02:40Alkynes to Aldehydes and Ketones: Acid-Catalyzed Hydration
Analogous to alkenes, alkynes also undergo acid-catalyzed hydration. While the addition of water to an alkene gives an alcohol, hydration of alkynes produces different products such as aldehydes and ketones.
01:16Amines to Alkenes: Hofmann Elimination
Under thermal conditions, the hydroxide can abstract a proton from the β carbon; this generates an alkene with the simultaneous...
01:26Preparation of 1° Amines: Hofmann and Curtius Rearrangement Mechanism