An Analysis of the Effect of Activation Temperature and Crack Geometry on the Healing Efficiency of Polycaprolactone...

Self-healing materials have attracted great interest in recent years. Particularly, the use of thermoset/thermoplastics blends has emerged as a good option with relatively low activation temperatures and potential infinite healing cycles. Nevertheless, a methodical study of healing conditions and evaluation is still required for further industrial development. The effect of activation temperature and crack morphology in polycaprolactone (PCL)/epoxy blends are explored. For this purpose, PCL content was varied (5, 10, and 15 wt %) with contents lower than critical composition. Therefore, the morphology of all studied blends is the epoxy matrix with a separated PCL phase. In this sense, an increase in PCL content leads to a reduction in the Tg, due to the partial PCL miscibility, and the presence of larger PCL domains. It was observed that a higher temperature (150 °C) and PCL content led to a more efficient self-healing process because of both the lower viscosity of the melted PCL at higher temperatures and the presence of larger PCL reservoirs when increasing the PCL content. Crack morphology influence was studied by inducing cracks with different tools: a custom crack machine with a cutting blade, a scalpel, and a pin. The results show that the recovery was better when the cracks were smaller and shallower, that is, with the pin. In addition, the healing efficiency by means of both parameters, crack volume and depth change, showed more similar results in slimmer cracks, due to a lower crack width-to-depth ratio.