Enthalpies of formation for Criegee intermediates: A correlation energy convergence study

James M Begley1, Gustavo J R Aroeira1, Justin M Turney1

  • 1Department of Chemistry, Center for Computational Quantum Chemistry, University of Georgia, Athens, Georgia 30602, USA.

Related Concept Videos

Enthalpies of Reaction03:33

Enthalpies of Reaction

Hess’s law can be used to determine the enthalpy change of any reaction if the corresponding enthalpies of formation of the reactants and products are available. The main reaction may be divided into stepwise reactions : (i) decompositions of the reactants into their component elements, for which the enthalpy changes are proportional to the negative of the enthalpies of formation of the reactants, −ΔHf°(reactants), followed by (ii) re-combinations of the elements (obtained...
32.7K
Energy Diagrams, Transition States, and Intermediates02:13

Energy Diagrams, Transition States, and Intermediates

Free-energy diagrams, or reaction coordinate diagrams, are graphs showing the energy changes that occur during a chemical reaction. The reaction coordinate represented on the horizontal axis shows how far the reaction has progressed structurally. Positions along the x-axis close to the reactants have structures resembling the reactants, while positions close to the products resemble the products.  Peaks on the energy diagram represent stable structures with measurable lifetimes, while...
16.9K
Standard Enthalpy of Formation02:37

Standard Enthalpy of Formation

Enthalpy changes are typically tabulated for reactions in which both the reactants and products are at the same conditions. A standard state is a commonly accepted set of conditions used as a reference point for the determination of properties under other different conditions. For chemists, the IUPAC standard state refers to materials under a pressure of 1 bar and solutions at 1 M and does not specify a temperature. Many thermochemical tables list values with a standard state of 1 atm. Because...
42.1K
Regioselective Formation of Enolates01:33

Regioselective Formation of Enolates

As depicted in the figure below, the unsymmetrical ketones can form two possible enolates:  less substituted or more substituted enolates. Usually, the thermodynamic enolates are formed from the more substituted α-carbon atom, while the kinetic enolates are formed faster by deprotonation from the less substituted position. The thermodynamic enolates have lower energy, so they are  more stable. But the energy required to form kinetic enolates is less.
2.8K
Energetics of Solution Formation02:35

Energetics of Solution Formation

The formation of a solution is an example of a spontaneous process, which is a process that occurs under specified conditions without energy from some external source.
When the strengths of the intermolecular forces of attraction between solute and solvent species in a solution are no different than those present in the separated components, the solution is formed with no accompanying energy change. Formation of the solution requires the solute–solute and solvent–solvent...
6.8K
Stability of Conjugated Dienes01:28

Stability of Conjugated Dienes

Introduction
A comparison of the enthalpies of hydrogenation of dienes reveals that conjugated dienes release less heat on hydrogenation, rendering them more stable than their nonconjugated analogs.
3.5K