Biomechanical Comparison Between Posterior Long-Segment Fixation, Short-Segment Fixation, and Short-Segment Fixation With Intermediate Screws for the Treatment of Thoracolumbar Burst Fracture: A Finite Element Analysis
Related Experiment Video
Updated: Aug 13, 2025
Minimally Invasive Treatment for Thoracolumbar Burst Fracture Using Sagittal Alignment Screws and A Trauma Reduction Device
Published on: November 8, 2024
Worawat Limthongkul1,2, Nutthee Wannaratsiri3, Chamaiporn Sukjamsri4
1Department of Orthopedics, Faculty of Medicine, Chulalongkorn University and King Chulalongkorn Memorial Hospital, Bangkok, Thailand.
Background:
Posterior long-segment (LS) fixation, short-segment (SS) fixation, and short segment fixation with intermediate screws (SI) have shown good outcomes for the treatment of thoracolumbar burst fractures. However, limited data compared the biomechanical properties between LS fixation and SI. The purpose of this study was to compare the von Mises stresses on the pedicular screw system and bone between posterior LS fixation, SS fixation, and SI for the treatment of thoracolumbar burst fracture.
Materials And Methods:
The finite element model of thoracolumbar spines from T11 to L3 was created based on the computed tomography image of a patient with a burst fracture of the L1 vertebral body. The models of pedicular screws, rods, and locking nuts were constructed based on information from the manufacturer. Three models with different fixation configurations-that is, LS, SS, and SI-were established. The axial load was applied to the superior surface of the model. The inferior surface was fixed. The stress on each screw, rod, and vertebral body was analyzed.
Results:
The motion of the spine in SS (0.5 mm) and SI (0.9 mm) was higher than in LS (0.2 mm). In all models, the lowest pedicle screws are the most stressed. The stress along the connecting rods was comparable between SI and LS (50 MPa). At the fracture level, stress was found at the pedicles and vertebral bodies in SI. There was relatively little stress around the fractured vertebral body in LS and SS.
Conclusions:
Posterior SI preserves more spinal motion than the LS. In addition, it provides favorable biomechanical properties than the SS. The stress that occurred around the pedicle screws in SI was the least among the 3 constructs, which might reduce complications such as implant failure. SI produces more stress in the fractured vertebral body than LS and SS, which could potentially aid in bone healing according to the Wolff law.
Clinical Relevance:
SI has proved to be a biomechanically favorable construct and helps preserve the spinal motion segment. It could be an alternative surgical option for treating patients who present with thoracolumbar burst fractures.
