Digital Control of a Superconducting Qubit Using a Josephson Pulse Generator at 3 K

Scaling of quantum computers to fault-tolerant levels relies critically on the integration of energy-efficient, stable, and reproducible qubit control and readout electronics. In comparison to traditional semiconductor-control electronics (TSCE) located at room temperature, the signals generated by rf sources based on Josephson-junctions (JJs) benefit from small device sizes, low power dissipation, intrinsic calibration, superior reproducibility, and insensitivity to ambient fluctuations. Previous experiments to colocate qubits and JJ-based control electronics have resulted in quasiparticle poisoning of the qubit, degrading the coherence and lifetime of the qubit. In this paper, we digitally control a 0.01-K transmon qubit with pulses from a Josephson pulse generator (JPG) located at the 3-K stage of a dilution refrigerator. We directly compare the qubit lifetime T ₁, the coherence time $T_2^{*}$ , and the thermal occupation P _th when the qubit is controlled by the JPG circuit versus the TSCE setup. We find agreement to within the daily fluctuations of ±0.5 micros and ±2 micros for T ₁ and $T_2^{*}$ , respectively, and agreement to within the 1% error for P _th. Additionally, we perform randomized benchmarking to measure an average JPG gate error of 2.1 × 10^-2. In combination with a small device size (< 25 mm²) and low on-chip power dissipation (≪100 microW), these results are an important step toward demonstrating the viability of using JJ-based control electronics located at temperature stages higher than the mixing-chamber stage in highly scaled superconducting quantum information systems.