Cyclopropane as an Unsaturation "Effect Isostere": Lowering the Melting Points in Lipid-like Ionic Liquids

The replacement of unsaturation with a cyclopropane motif as a (bio)isostere is a widespread strategy in bacteria to tune the fluidity of lipid bilayers and protect membranes when exposed to adverse environmental conditions, e.g., high temperature, low pH, etc. Inspired by this phenomenon, we herein address the relative effect of the cyclopropanation, both cis and trans configurations, on melting points, packing efficiency, and order of a series of lipid-like ionic liquids via a combination of thermophysical analysis, X-ray crystallography, and computational modeling. The data indicate there is considerable structural latitude possible when designing highly lipophilic ionic liquids that exhibit low melting points. While cyclopropanation of the lipid-like ionic liquids provides more resistance to aerobic degradation than their olefin analogs, the impact on the melting point decrease is not as pronounced. Our results demonstrate that incorporating one or more cyclopropyl moieties in long aliphatic chains of imidazolium-based ionic liquids is highly effective in lowering the melting points of such materials relative to their counterparts bearing linear, saturated, or thioether side chains. It is shown that the cyclopropane moiety effectively disrupts packing, favoring formation of gauche conformer in the side chains, resulting in enhancement of fluidity. This was irrespective of the configuration of the methylene bridge, although marked differences in the effect of cis- and trans-monocyclopropanated ILs on the melting points were observed.