Process design and optimization on self-sustaining pyrolysis and carbonization of municipal sewage sludge

Pyrolysis can realize the reduction and resource utilization of municipal sewage sludge (MSS). In this paper, a self-sustaining pyrolysis process is designed for municipal sewage sludge, and the process flow is simulated by Aspen plus software. By changing the initial moisture content of sludge, moisture content after drying, pyrolysis temperature and air supply in the incinerator, the possibility of achieving energy self-balance in the system is analysed. The simulation results show that by adjusting the parameters of the system, this process can realize the energy self-balance of sludge drying and pyrolysis treatment. Considering the system's energy loss, the dry basis calorific value of sludge should not be less than 10 MJ/kg. The higher the initial moisture content of sludge, the more external energy input the system needs. It is recommended to dehydrate sludge mechanically to about 60 % before entering the system. When the pyrolysis temperature is increased, the amount of oil and gas produced by sludge pyrolysis increases, and it is easier to achieve self-balance of system energy. But the higher the pyrolysis temperature, the greater the energy consumption required. In practice, it is suggested that the pyrolysis temperature is about 400 °C. The moisture content of dried sludge has little effect on the energy self-balance of the system, and it is recommended to be about 30 %. The air supply volume of the incinerator mainly affects the flue gas outlet temperature and flue gas volume, but has little effect on the energy balance of the system.