Efficacy of 810 nm and 650 nm Diode Laser Alone and in Combination With Sodium Fluoride Gel in Treating Dentin...

Introduction Dentin hypersensitivity has been defined as a short, sharp pain caused by exposing naked dentin to external stimuli such as evaporation, heat, cold, osmotic liquids, and tactile effects. None of the available treatments has been considered the gold standard in treating dentin hypersensitivity. The use of laser has recently become more popular, and it is a promising treatment method in this field. The study aimed to compare the effectiveness of both 810 nm and 650 nm diode lasers in treating dentin hypersensitivity. Materials and methods This study was conducted on six patients who were referred to the Department of Oral Medicine, Faculty of Dental Medicine, Damascus University (4 females and 2 males) with 108 teeth suffering from generalized dentin hypersensitivity and were randomly divided into two groups. Group 1 consisted of three patients with 50 teeth treated with an 810 nm diode laser; it was divided by the split-mouth design into two subgroups. The first subgroup was treated by the application of the laser alone toward the target area with 1-watt power, continuous mode, and a total application time of 90 seconds, and the second subgroup was treated by applying sodium fluoride gel for one minute, then the laser was applied with the same settings as the first subgroup. Group 2 consisted of three patients with 58 teeth treated with a 650 nm diode laser; it was divided by the split-mouth design into two subgroups. The first subgroup was treated by the application of the laser alone toward the target area with 200 m watt power, continuous mode, and a total application time of 120 seconds, and the second subgroup was treated by applying sodium fluoride gel for one minute and then applying the laser with the same settings as the first subgroup. The pain was evaluated using a numeric rating scale (NRS) of 100 degrees before and immediately after treatment, and then after three to six and nine months by applying an air stream from a dental chair syringe at a distance of 0.5 cm from the target area. Results This study showed that both types of lasers were effective in treating pain caused by dentinal hypersensitivity. The average values ​​of pain reduction on the NRS showed the superiority of the 810 nm diode laser over the 650 nm after treatment and at all time points of pain assessment. No statistically significant differences were detected between applying laser alone and applying it combined with sodium fluoride gel in pain reduction values. Conclusions The application of an 810 nm diode laser either alone or in combination with sodium fluoride gel in treating dentin hypersensitivity is effective and better than the application of a 650 nm diode laser either alone or in combination with sodium fluoride gel. In addition, applying a 650 nm diode laser either alone or in combination with sodium fluoride gel has slight effectiveness in treating dentine hypersensitivity, and it is believed that a single treatment session with a 650 nm diode laser was not enough to obtain the required pain reduction.