Insight into the Surface Reconstruction-Induced Structure and Electrochemical Performance Evolution for Ni-Rich...

Ni-rich layered LiNi_xCo_yAl_zO₂ (NCA, x ≥ 0.8) oxides have attracted wide attention as cathode materials for lithium-ion batteries due to their higher energy density and lower cost. However, the increase in the capacity for Ni-rich cathodes can cause faster capacity decay and increase sensitivity to ambient air exposure during the storage process. Especially, the residual lithium on the surface of Ni-rich cathodes will cause severe flatulence during cycling which greatly reduces the safety performance of the battery. Washing is an effective method to reduce residual lithium, but it will seriously damage the surface phase structure of Ni-rich materials. Here, we introduce a designed method involving two steps, washing and high-temperature annealing, which can ingeniously modify the surface phase structure of Ni-rich cathodes. The results show that the residual lithium content can be significantly reduced. The thin NiO-like rock-salt phase formed on the surface of Ni-rich cathode annealed at 600 °C improves the diffusion kinetics of Li⁺, reduces the polarization, and improves the electrochemical performance of Ni-rich materials, while the thick spinel-like phase formed at 400 °C hinders the diffusion kinetics of Li⁺, significantly increases the polarization, and eventually leads to the structural degradation of Ni-rich materials. As a result, the discharge capacity of the cathode annealed at 600 °C still retains 174.48 mA h g^-1 after 100 cycles, with a capacity retention of 92.04%, much larger than the cathode annealed at 400 °C, for which the discharge capacity drops to 107.77 mA h g^-1, with a capacity retention of 65.78%.