Related Experiment Video
Updated: Aug 10, 2025
An Improved Mechanical Testing Method to Assess Bone-implant Anchorage
Published on: February 10, 2014
Mechanical testing of transtibial prosthetic sockets: A discussion paper from the American Orthotic and Prosthetic
Francesca Gariboldi1, Andrea Giovanni Cutti2, Stefania Fatone3
1Department of Industrial Engineering, University of Padua, Padua (PD), Italy.
Background:
The advent of novel manufacturing technologies, materials, and socket design concepts could introduce risks to prosthetic limb users, as the existing knowledge base for safe fabrication may not apply. Moreover, although structural test standards exist for mass-produced prosthetic components, they are not applicable to prosthetic sockets.
Methods:
The "AOPA Socket Guidance Workgroup" was formed in 2020 to provide the prosthetic community with evidence-based clinical best practices and methods in the field of prosthetic socket structural analysis. This multidisciplinary expert workgroup undertook a critical analysis of the knowledge gaps regarding the requirements for mechanical testing of lower limb prosthetic sockets.
Results:
The Workgroup identified knowledge gaps in 4 domains. Domain 1 describes the shape and composition of a mock residual limb, required to support and generate in vivo representative loading within the socket. Domain 2 concerns prosthetic socket coordinate systems and alignment. Domain 3 regards the components and requirements of test specimens. Finally, Domain 4 considers test conditions, loading parameters, and acceptance criteria.
Conclusions:
This paper describes these knowledge gaps in detail and recommends potential solution approaches based on literature review, group consensus around existing knowledge, or the formation of new study groups to fill each knowledge gap. Our intent is for the recommendations arising from this paper to support the community (e.g., researchers in the clinic, academia, industry, and funders) in addressing these knowledge gaps.
