Related Experiment Video
Updated: Aug 9, 2025

Continuous-Wave Propagation Channel-Sounding Measurement System - Testing, Verification, and Measurements
Published on: June 25, 2021
Assessment of Galileo High Accuracy Service (HAS) test signals and preliminary positioning performance
Nacer Naciri1, Ding Yi1, Sunil Bisnath1
1Department of Earth and Space Science and Engineering, York University, Toronto, ON M3J 1P3 Canada.
Abstract:
The Galileo High Accuracy Service (HAS) is a GNSS augmentation that provides precise satellite corrections to users worldwide for free directly through Galileo's E6 signal. The HAS service provides free PPP corrections from the Galileo constellation and the Internet, with targeted real-time 95% positioning performance of better than 20 cm horizontal and 40 cm vertical error after 5 min of convergence time globally and shorter in Europe. The HAS initial service, under validation at the time of writing, provides these capabilities with a reduced performance (based on the current Galileo stations network). Live HAS test signals broadcasted from the Galileo satellites during summer 2022 have been decoded and analyzed. Corrections include Galileo and GPS orbit, clock, and code bias corrections, with SISRE of 10.6 cm and 11.8 cm for Galileo and GPS, respectively. Code bias corrections showed good performance as well, with rms of 0.28 ns, 0.26 ns, and 0.22 ns for Galileo C1C-C5Q, C1C-C7Q, and C1C-C6C, respectively, and 0.20 ns for GPS C1C-C2L. Float PPP positioning performance results show that the combined Galileo and GPS solution can already achieve the HAS full service accuracy performance target and is close in terms of convergence time, with 95% rms of 13.1 cm and 18.6 cm horizontally and vertically, respectively, in kinematic mode, and with a 95% convergence time of 7.5 min. The latter is expected to be improved with the inclusion of satellite phase bias and local atmospheric corrections. With these early Galileo HAS test signals, this preliminary analysis indicates that the HAS full service targets are attainable. Finally, a correction latency analysis is performed, showing that even with latency of up to 60 s, positioning can remain within the targeted HAS accuracy performance.
More Related Videos
Related Concept Videos
Errors in Global Positioning System
Types of Global Positioning System Surveys
Field Application of Global Positioning System
Design Example: Identifying the Locations of Monuments in the Field Using Global Positioning System Device
Introduction to Global Positioning System
Galvanometer
The galvanometer consists of two concave-shaped permanent magnets, providing a uniform radial magnetic field in the annular region. In the center, a pivoted coil of fine copper wire is placed in the uniform...

