The Effect of In-Office Bleaching with Different Concentrations of Hydrogen Peroxide on Enamel Color, Roughness, and...

The aim of this study is to evaluate the effectiveness of in-office bleaching in esthetic dentistry on the roughness and color stability of the enamel surface, using different concentrations of hydrogen peroxide (HP). Fifty human incisors were randomly divided into 5 groups (n = 10). No bleaching was performed in the control group. For these groups, concentrations of 40% HP with fluoride (F), 35% HP with calcium (Ca), 25% HP with nano-hydroxyapatite (nHA) and 18% HP with nHA were used for bleaching in the test groups. Surface roughness was assessed at baseline after bleaching occurred. Color measurements were first obtained at baseline, then after the first and second sessions of bleaching, and, finally, after the staining protocol. Scanning electron microscopy and atomic force microscopy were performed. Statistical analysis was conducted with a one-way ANOVA, followed by a post hoc Tukey's test and a paired-samples t-test (p < 0.05). All the bleaching gels used exhibited a similar color change (p > 0.05). Bleaching gels containing 18% HP with nHA and that containing 35% HP with Ca caused less surface roughness of the enamel. Of these concentrations, 25% HP with nHA caused the most surface roughness and no significant difference was observed, compared with 40% HP with F. The highest coloration after bleaching was observed in 40% HP with F and 25% HP with nHA. The lowest coloration was obtained in 35% HP with Ca and 18% HP with nHA but no significant difference was observed between them and the control group. A concentration above 18% HP does not increase the bleaching effectiveness. The results show that 18% HP with nHA and 35% HP with Ca resulted in the least increase in enamel surface roughness when compared to high-concentrate HP; however, it also prevented recoloration after bleaching.