Related Experiment Video
Updated: Aug 8, 2025

Low Pressure Vapor-assisted Solution Process for Tunable Band Gap Pinhole-free Methylammonium Lead Halide Perovskite Films
Published on: September 8, 2017
Theory of Hysteresis in Halide Perovskites by Integration of the Equivalent Circuit
Juan Bisquert1, Antonio Guerrero1, Cedric Gonzales1
1Institute of Advanced Materials (INAM), Universitat Jaume I, 12006 Castelló, Spain.
Abstract:
Perovskite solar cells show a number of internal electronic-ionic effects that produce hysteresis in the current-voltage curves and a dependence of the temporal response on the conditions of the previous stimulus applied to the sample. There are many models and explanations in the literature, but predictive methods that may lead to an assessment of the solar cell behavior based on independent measurements are needed. Here, we develop a method to predict time domain response starting from the frequency domain response measured by impedance spectroscopy over a collection of steady states. The rationale of the method is to convert the impedance response into a set of differential equations, in which the internal state variables emerge naturally and need not be predefined in terms of a physical (drift/diffusion/interfaces) model. Then, one solves (integrates) the evolution for a required external perturbation such as voltage sweep at a constant rate (cyclic voltammetry). Using this method, we solve two elementary but relevant equivalent circuit models for perovskite solar cells and memristors, and we show the emergence of hysteresis in terms of the relevant time and energy constants that can be fully obtained from impedance spectroscopy. We demonstrate quantitatively a central insight in agreement with many observations: regular hysteresis is capacitive, and inverted hysteresis is inductive. Analysis of several types of perovskite solar cells shows excellent correlation of the type of equivalent circuit and the observed hysteresis. A new phenomenon of transformation from capacitive to inductive hysteresis in the course of the current-voltage curve is reported.
More Related Videos
11:38Influence of Hybrid Perovskite Fabrication Methods on Film Formation, Electronic Structure, and Solar Cell Performance
Published on: February 27, 2017
04:14Facile Synthesis of Colloidal Lead Halide Perovskite Nanoplatelets via Ligand-Assisted Reprecipitation
Published on: October 1, 2019
Related Concept Videos
Equivalent Capacitance
Biasing of Metal-Semiconductor Junctions
In Schottky junctions, where the semiconductor is n-type, applying a positive voltage to the metal relative to the semiconductor reduces its Fermi...
Impedance Combination
Integrator and Differentiator
An integrator within an op-amp circuit produces an output directly proportional to the integral of the input signal. This is achieved by replacing the feedback resistor in a typical inverting...
Carrier Generation and Recombination
This process is given by the generation rate G and is efficient due to the conservation of momentum between the valence band maximum and conduction band minimum.
Indirect generation involves an...
Metal-Semiconductor Junctions
Schottky Barriers
Schottky barriers arise when a metal with a work function (Φm) contacts a semiconductor with a different work function (Φs). Initially, electrons transfer until the Fermi levels of the metal and semiconductor align at equilibrium. For instance, if Φm > Φs, the semiconductor Fermi level is higher than the metal's before contact. The...