Food aeration: Effect of the surface-active agent type on bubble deformation and break-up in a viscous Newtonian...

Two continuous whipping devices, a rotor-stator (RS) and a narrow angular gap unit (NAGU), were used to produce aerated food with a 25% (v/v) gas fraction target. The liquid phase was a Newtonian model-solution containing 2% (w/w) of either whey proteins (WPC), sodium caseinate (SCN), or tween 20 (TW20). Strong differences emerged regarding gas incorporation and bubble size as a function of process parameters: namely, rotation speed and residence time. To improve understanding of the results obtained at pilot-scale, a second investigation consisting in the observation of the deformation and break-up of single gas bubbles has been undertaken using successively a Couette device and an impeller close to NAGU. For proteins, the observation of single bubble deformation and break-up showed that bubble break-up occurred by tip-streaming above a well-defined critical Capillary number Ca_c of 0.27 and 0.5 for SCN and WPC, respectively, whereas no break-up was observed with TW20 even though Ca reached 10. The poor foaming ability obtained with TW20 could be explained by a poor break-up mechanism, promoting coalescence and gas plugs at high shear instead of gas incorporation. Conversely, protein promote tip-streaming as the major break-up mechanism at low shear rate, explaining why rotation speed is not a key process parameter. Differences observed between SCN and WPC can be attributed to diffusion limitation for SCN when a much larger surface area is generated during aeration.