Assessing the coronal plane deformity in Charcot Marie Tooth Cavovarus feet using automated 3D measurements

This study assesses the coronal-plane deformities in cavovarus feet secondary to Charcot-Marie-Tooth disease (CMT) using Weightbearing-CT (WBCT) and semi-automated 3D-segmentation software.

WBCTs from 30 CMT-cavovarus feet were matched to 30 controls and analysed using semi-automatic 3D-segmentation (Bonelogic, DISIOR). The software used automated cross-section sampling with subsequent straight-line representation of weighted centre points to calculate 3D axes of bones in the hindfoot, midfoot and forefoot. Coronal relationships of these axes were analysed. Supination/pronation of the bones in relation to the ground and within each joint were measured and reported.

The most significant deformity in CMT-cavovarus feet occurred at the talonavicular joint (TNJ) with 23 degrees more supination than normal feet (6.4 ± 14.5 versus 29.4 ± 7.0 degrees, p < 0.001). This was countered by relative pronation at the naviculo-cuneiform joints (NCJ) of 7.0 degrees (-36.0 ± 6.6 versus -43.0 ± 5.3 degrees, p < 0.001). Combined hindfoot varus and TNJ supination resulted in an additive supination effect not compensated by NCJ pronation. The cuneiforms in CMT-cavovarus feet were therefore supinated by 19.8 degrees to the ground relative to normal feet (36.0 ± 12.1 versus 16.2 ± 6.8 degrees, p < 0.001). The forefoot-arch and 1st metatarsal-ground angles demon^strated similar supination to the cuneiforms suggesting no further significant rotation occurred distally.

Our results demonstrate coronal plane deformity occurs at multiple levels in CMT-cavovarus feet. Majority of the supination arises at the TNJ, and this is partially countered by pronation distally, mainly at the NCJ. An understanding of the location of coronal deformities may help when planning surgical correction.

Level III, retrospective comparative study.