Related Experiment Video

Updated: Aug 8, 2025

Visualizing Visual Adaptation
04:43

Visualizing Visual Adaptation

Published on: April 24, 2017

9.0K

Effects of surrounding and underlying shades on the color adjustment potential of a single-shade composite used in a

Mariana Silva Barros1, Paula Fernanda Damasceno Silva1, Márcia Luciana Carregosa Santana1

  • 1Department of Dentistry, Federal University of Sergipe, Aracaju, SE, Brazil.

Restorative Dentistry & Endodontics
|March 6, 2023
PubMed
Abstract

Keywords:
ColorComposite resinsDental materialsDental restoration, PermanentEsthetics, Dental

More Related Videos

Fabrication of Ultra-thin Color Films with Highly Absorbing Media Using Oblique Angle Deposition06:30

Fabrication of Ultra-thin Color Films with Highly Absorbing Media Using Oblique Angle Deposition

Published on: August 29, 2017

8.3K
Applying Hyperspectral Reflectance Imaging to Investigate the Palettes and the Techniques of Painters07:05

Applying Hyperspectral Reflectance Imaging to Investigate the Palettes and the Techniques of Painters

Published on: June 18, 2021

2.5K

Related Concept Videos

Changes in Skin Color: Clinical Perspectives01:14

Changes in Skin Color: Clinical Perspectives

The first thing a clinician sees is the skin, so the examination of the skin should be part of any thorough physical examination. Most skin disorders are relatively benign, but a few, including melanomas, can be fatal if untreated. A couple of the more noticeable disorders, albinism and vitiligo, affect the appearance of the skin and its accessory organs.
Albinism
Albinism is a genetic disorder that affects (completely or partially) the coloring of skin, hair, and eyes. The defect is primarily...
2.0K
Color Vision01:24

Color Vision

Color perception begins in the retina, the light-sensitive layer at the back of the eye. Two main theories explain how colors are seen: the trichromatic theory and the opponent-process theory. The trichromatic theory, proposed by Thomas Young in 1802 and extended by Hermann von Helmholtz in 1852, suggests that color vision is based on three types of cone receptors in the retina. These cones are sensitive to different but overlapping ranges of wavelengths corresponding to red, blue, and green.
637
Pigmentation01:19

Pigmentation

The color of the skin is influenced by a number of pigments, including melanin, carotene, and hemoglobin. Recall that melanin is produced by cells called melanocytes, which are found scattered throughout the stratum basale of the epidermis. The melanin is transferred to the keratinocytes via melanosomes.
Melanin occurs in two primary forms: eumelanin that provides black and brown pigment and pheomelanin that provides red color. Dark-skinned individuals produce more melanin than those with pale...
2.5K
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
6.7K
Photoreceptors and Visual Pathways01:22

Photoreceptors and Visual Pathways

At the molecular level, visual signals trigger transformations in photopigment molecules, resulting in changes in the photoreceptor cell's membrane potential. The photon's energy level is denoted by its wavelength, with each specific wavelength of visible light associated with a distinct color. The spectral range of visible light, classified as electromagnetic radiation, spans from 380 to 720 nm. Electromagnetic radiation wavelengths exceeding 720 nm fall under the infrared category,...
6.2K
Design Example: Aggregate Gradation01:24

Design Example: Aggregate Gradation

The right type and quality of aggregates are crucial for concrete as they significantly influence its properties, mix proportions, and cost-effectiveness. If different sources are available for sand, the commonly used fine aggregate in concrete, the selection of sand is primarily based on its gradation.
The grading, or particle-size distribution, of sand is determined using sieve analysis, with standard sizes ranging from 150 μm to 10 mm (ASTM No. 100 sieve to 3⁄8 in. sieve). Sand is...
136