Influence of Material Removal Strategy on Machining Deformation of Aluminum Plates with Asymmetric Residual Stresses

In this paper, the effects of material removal strategies and initial stress states on the machining deformation of aluminum alloy plates were investigated through a combination of finite element simulation and experiments. We developed different machining strategies described by Tm+Bn, which removal m mm materials form top and n mm materials from the bottom of the plate. The results demonstrate that the maximum deformation of structural components with the T10+B0 machining strategy could reach 1.94 mm, whereas with the T3+B7 machining strategy was only 0.065 mm, decreasing by more than 95%. The asymmetric initial stress state had a significant impact on the machining deformation of the thick plate. The machined deformation of thick plates increased with the increase in the initial stress state. The concavity of the thick plates changed with the T3+B7 machining strategy due to the asymmetry of the stress level. The deformation of frame parts was smaller when the frame opening was facing the high-stress level surface during machining than when it was facing the low-stress level. Moreover, the modeling results for the stress state and machining deformation were accurate and in good accordance with the experimental findings.