Temperature dependence of electrical conductivity and variable hopping range mechanism on graphene oxide films

The rapid development of optoelectronic applications for optical-to-electrical conversion has increased the interest in graphene oxide material. Here, graphene oxide films (GOF) were used as source material in an infrared photodetector configuration and the temperature dependence of the electrical conductivity was studied. GOF were prepared by the double-thermal decomposition (DTD) method at 973 K, with a fixed carbonization temperature, in a pyrolysis system, under a controlled nitrogen atmosphere, over quartz substrates. Graphene oxide films were mechanically supported in a photodetector configuration on Bakelite substrates and electrically contacted with copper wires and high-purity silver paint. Morphological images from the GOF's surface were taken employing a scanning electron microscope and observed a homogeneous surface which favored the electrical contacts deposition. Vibrational characteristics were studied employing Raman spectroscopy and determined the typical graphene oxide bands. GOF were used to discuss the effect of temperature on the film's electrical conductivity. Current-voltage (I-V) curves were taken for several temperatures varying from 20 to 300 K and the electrical resistance values were obtained from 142.86 to 2.14 kΩ. The GOF electrical conductivity and bandgap energy (E_g) were calculated, and it was found that when increasing temperature, the electrical conductivity increased from 30.33 to 2023.97 S/m, similar to a semiconductor material, and E_g shows a nonlinear change from 0.33 to 0.12 eV, with the increasing temperature. Conduction mechanism was described mainly by three-dimensional variable range hopping (3D VRH). Additionally, measurements of voltage and electrical resistance, as a function of wavelength were considered, for a spectral range between 1300 and 3000 nm. It was evidenced that as the wavelength becomes longer, a greater number of free electrons are generated, which contributes to the electrical current. The external quantum efficiency (EQE) was determined for this proposed photodetector prototype, obtaining a value of 40%, similar to those reported for commercial semiconductor photodetectors. This study provides a groundwork for further development of graphene oxide films with high conductivity in large-scale preparation.