Related Experiment Video
Updated: Aug 5, 2025

08:39
Fabrication of Compressed Hosiery and Measurement of its Pressure Characteristic Exerted on the Lower Limbs
Published on: May 27, 2020
2.4K
Stiffness of a Novel Two Layer Compression Stocking with 100% Donning and Doffing Success
Caroline S Buset1, Mena Gujan1, Clara Richter1
1Department of Dermatology, University Hospital of Zurich, Zurich, Switzerland.
Abstract
No abstract available in PubMed .
Keywords:
Dynamic stiffness indexEase of donning and doffingNovel two layer compression stockingPlethysmographyStatic stiffness indexVenous ejection fractionMore Related Videos
04:34A Novel Non-invasive Method for the Detection of Elevated Intra-compartmental Pressures of the Leg
Published on: May 31, 2019
9.3K
10:47Tri-layered Electrospinning to Mimic Native Arterial Architecture using Polycaprolactone, Elastin, and Collagen: A Preliminary Study
Published on: January 4, 2011
13.0K
Related Concept Videos
Peripheral Artery Disease V: Postoperative Nursing Management
14
During the postoperative period, it is crucial to focus on maintaining circulation, identifying and managing potential complications, and planning for discharge.Nursing AssessmentVital signs monitoring: Regularly monitor vital signs, including blood pressure, heart rate, respiratory rate, and temperature, to detect early signs of complications such as bleeding and infection.Circulation assessment: Monitor pulses, perform Doppler assessments, and check capillary refill, color, temperature, and...
14
PPE Use in Healthcare Settings I: Donning
1.1K
Donning PPE must be completed before contact with the patient. This process protects from infectious agents. The sequence and action included in each donning are critical, and the steps must be systematic to avoid exposure to pathogens. The institutional policy also needs to be followed while donning PPE. The pre-donning preparations are gathering equipment, inspecting the PPE equipment for tears, holes, or damage, removing jewelry, removing any garments below the elbows, and tying the hair...
1.1K
Temperature Dependent Deformation
176
In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added...
176