Related Experiment Video
Updated: Aug 5, 2025

Two-way Valorization of Blast Furnace Slag: Synthesis of Precipitated Calcium Carbonate and Zeolitic Heavy Metal Adsorbent
Published on: February 21, 2017
Study on Long Term Property of Soft Soil Solidified with Industrial Waste Residue and Regenerated Fine Aggregate
Anhui Wang1,2, Wanying Dong3, Qiwei Zhan3
1China Construction Industrial & Energy Engineering Group Co., Ltd., Nanjing 210046, China.
Abstract:
The long-term properties of solidified soft soil, including an immersion test, the dry-wet cycle and the freeze-thaw cycle, were systematically studied. Firstly, the immersion stability of solidified soft soil was confirmed. The appearance of soft soil solidified by a solidified agent and raw fine aggregate did not change significantly, and it was still intact without damage when the soaking time increased up to 28 d. Secondly, the mass and compressive strength loss of solidified soft soil were determined. When the number of dry-wet cycles was one, three, five and seven, the accumulated-mass loss rate was 1.4%, 3.0%, 4.5% and 6.0%, respectively, and the compressive-strength loss rate was -10.3%, 13.9%, 41.2% and 53.6%, respectively. Compared with solidified soft soil under standard curing environments, solidified soft soil after seven dry-wet cycles showed small cracks, and the structural compactness began to decline. Finally, the influence of the freeze-thaw cycle on the mass, compressive strength and microstructure of solidified soft soil was confirmed. When the number of freeze-thaw cycles was 5, 10, 15 and 20, the accumulated-mass loss rate was 12.6%, 16.7%, 17.9% and 18.8%, respectively. The microstructure of the solidified soft soil was damaged, and the increase in porosity was the main reason for its strength reduction or even failure. Nevertheless, soft soil with a solidified agent and recycled fine aggregate had no obvious damage to the microstructure, and the freeze-thaw resistance was relatively superior.
More Related Videos
Related Concept Videos
Deleterious Substances in Aggregate
Another type of impurity is clay and fine material that...
Unsoundness of Aggregate due to Volume Change
Design Example: Aggregate Gradation
The grading, or particle-size distribution, of sand is determined using sieve analysis, with standard sizes ranging from 150 μm to 10 mm (ASTM No. 100 sieve to 3⁄8 in. sieve). Sand is...
Factors Affecting Workability
Abrasion Resistance of Concrete
One such test is the revolving disc test, where three plates...
Design Example: Managing Concrete Workability

