Polymer-Based Additive Manufacturing for Orthotic and Prosthetic Devices: Industry Outlook in Canada

The conventional manufacturing methods for fabricating orthotic and prosthetic (O&P) devices have been in practice for a very long time. Recently, O&P service providers have started exploring different advanced manufacturing techniques. The objective of this paper is to perform a mini review on recent progress in the use of polymer-based additive manufacturing (AM) for O&P devices and to gather insights from the O&P professionals on the current practices and technologies and on the prospect of using AM techniques in this field. In our study, first, scientific articles on AM for O&P devices were studied. Then, twenty-two (22) interviews were conducted with O&P professionals from Canada. The primary focus was on five key areas: cost, material, design and fabrication efficiency, structural strength, functionality, and patient satisfaction. The cost of manufacturing the O&P devices using AM techniques is lower as compared to the conventional methods. O&P professionals expressed their concern over the materials and structural strength of the 3D-printed prosthetic devices. Published articles report comparable functionality and patient satisfaction for both O&P devices. AM also greatly improves design and fabrication efficiency. However, due to a lack of qualification standards for 3D printed O&P devices, 3D printing is being embraced more slowly in the O&P business than in other industries.