Mechanical, microstructural and fracture studies on inconel 825-SS316L functionally graded wall fabricated by wire...

This paper presents a novel method that uses the cold metal transfer based wire arc additive manufacturing process to fabricate functionally graded Inconel 825-SS316L walls. The optical micrograph of Inconel 825 exhibits continuous and discontinuous dendritic structures. The SS316L region comprises 5% of δ-ferrite in primary austenitic (γ) dendrites which was confirmed by the Cr_eq/Ni_eq ratio of 1.305. The functionally graded interface reveals a partially mixed zone with a transition from the elongated dendrites to fine equiaxed dendrites. The tensile properties of the fabricated wall were determined at room temperature using specimens extracted from Inconel 825, SS316L, and the interface regions. The morphology of the tensile tested specimens revealed significant plastic deformation, indicating ductile failure. The fracture toughness of the wall was experimentally investigated by employing the crack tip opening displacement (CTOD) test. The fracture morphology exhibited a ductile mode of fracture with striations perpendicular to the direction of crack development. Elemental mapping revealed that there was no evidence of elemental segregation on the fractured surfaces, and the elements were uniformly dispersed. The CTOD measures 0.853 mm, 0.873 mm on the Inconel 825 side and the SS316L side respectively. The test results confirm that both the Inconel 825 and SS316L sides have good fracture toughness.