Blending bauxite residues with multiple byproducts improves capping materials for tailings storage facilities

Amelioration and management of large volumes of tailings resulting from alumina refining is a major challenge owing to the high alkalinity and salinity of residues. Blended byproduct caps are a potential new and more cost-effective approach to tailings management, where tailings are blended with other local byproducts in order to reduce pH, salinity and toxic elements. Here, alkaline bauxite residue was blended with four byproducts (waste acid, sewage water, fly ash and eucalypt mulch) to create a range of potential capping materials. We leached and weathered materials in the glasshouse with deionized water over nine weeks to investigate if byproducts on their own or in combination improved cap conditions. Combining all four byproducts (10 wt % waste acid, 5 wt % sewage water, 20 wt % fly ash and 10 wt % eucalypt mulch) achieved lower pH (9.60) compared to any byproduct applied individually, or un-remediated bauxite residue (pH 10.7). Leaching decreased EC by dissolving and exporting salts and minerals from the bauxite residue. Fly ash addition increased organic carbon (likely from non-combusted organic material) and nitrogen, while eucalypt mulch increased inorganic phosphorus. Addition of byproducts also decreased the concentration of potentially toxic elements (e.g., Al, Na, Mo and V) and enhanced pH neutralisation. Initial pH with single byproduct treatments was 10.4-10.5, which decreased to between 9.9-10.0. Further lowering of pH and salinity as well as increased nutrient concentrations may be possible through higher addition rates of byproducts, incorporation of other materials such as gypsum, and increasing leaching/weathering time of tailings in situ.