Related Experiment Video
Updated: Aug 3, 2025

Production and Analysis of Sporosarcina pasteurii Biocement Bricks Using Custom 3D-Printed Molds for Unconfined Compression Tests
Published on: March 7, 2025
Effects of Nitrite/Nitrate-Based Accelerators on Strength and Deformation of Cementitious Repair Materials under
Heesup Choi1, Masumi Inoue1, Hyeonggil Choi2
1Department of Civil and Environmental Engineering, Kitami Institute of Technology, Kitami 090-8507, Japan.
Abstract:
This study aimed to develop a cementitious repair material that can be constructed in cold weather conditions. The addition of nitrite/nitrate-based antifreezing agents has been shown to increase the initial strength of cementitious repair materials in cold weather. However, increasing the amount of these agents may lead to an increase in deformation behavior and shrinkage cracking. In this study, the effects of different types and amounts of nitrite/nitrate-based antifreezing agents on the strength development and deformation behavior of cementitious repair materials under low-temperature conditions were evaluated. As a result, it was found that the addition of a large amount of calcium nitrite can promote hydration and improve the initial strength of the repair material, irrespective of the type of antifreezing agent. However, this also leads to an increase in shrinkage and the concern of shrinkage cracking. Therefore, a repair material that is repairable in winter was developed by balancing the initial strength and deformation behavior through the appropriate selection of antifreezing agents. The developed repair material can be used to repair structures in cold weather conditions, which is of great significance for the construction industry in Hokkaido, Japan.
More Related Videos
Related Concept Videos
Accelerators
The effectiveness of calcium chloride can...
Types of Cement I
Type I (Ordinary Portland Cement) is widely used for general construction where special properties are not required. It has moderate sulfate resistance and heat of hydration.
Type II (Modified Cement) offers moderate resistance to sulfate attack and a lower rate of heat development compared to Type I. It is suitable for structures in...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Accelerated Curing of Concrete
Strength and Heat of Hydration
The heat of hydration for each cement compound is significant; for instance, tricalcium aluminate (C3A) and...
Curing of Concrete

