Comparison of Protein Particle Formation in IgG1 mAbs Formulated with PS20 Vs. PS80 When Subjected to Interfacial...

Polysorbates (PS) are nonionic surfactants that are commonly included in protein formulations to mitigate the formation of interfacial stress-induced protein particles and thus increase their long-term storage stability. Nonetheless, factors that dictate the efficiency of different polysorbates in mitigating protein particle formation, especially during the application of interfacial stresses, are often ill defined. Here, we used a Langmuir trough to determine the surface activity of two IgG1 monoclonal antibodies formulated with two different polysorbates (PS20 and PS80) when subjected to interfacial dilatational stress. Interfacial properties of these formulations were then correlated with characterization of subvisible protein particles measured by micro-flow imaging (MFI). Both mAbs, when formulated in PS20, demonstrate faster adsorption kinetics and higher surface activity compared to PS80 or surfactant-free formulations. Compression/expansion results suggest that when exposed to interfacial dilatational stresses, both mAb/PS20 formulations display interfacial properties of PS20 alone. In contrast, interfacial properties of both mAb/PS80 formulations suggest mAbs and PS80 are co-adsorbed to the air-water interface. Further, MFI analysis of the interface and the bulk solution confirms that PS20 is more effective than PS80 at mitigating the formation of larger particles in the bulk solution in both mAbs. Concomitantly, the efficiency of PS to prevent interface-induced protein particle formation also depended on the protein's inherent tendency to aggregate at a surfactant-free interface. Together, the studies presented here highlight the importance of determining the interfacial properties of mAbs, surfactants, and their combinations to make informed formulation decisions about the choice of surfactant.