Development of a Unified Specimen for Adhesive Characterisation-Part 1: Numerical Study on the Mode I (mDCB) and II...

Adhesives are increasingly being employed in industrial applications as a replacement for traditional mechanical joining methods, since they enable improvements in the strength-to-weight ratio and lower the cost of the overall structures. This has led to a need for adhesive mechanical characterisation techniques that can provide the data needed to build advanced numerical models, allowing structural designers to expedite the adhesive selection process and grant precise optimisation of bonded connection performance. However, mechanically mapping the behaviour of an adhesive involves numerous different standards resulting in a complex network of various specimens, testing procedures and data reduction methods that concern techniques which are exceedingly complex, time-consuming, and expensive. As such, and to address this problem, a novel fully integrated experimental characterisation tool is being developed to significantly reduce all the issues associated with adhesive characterisation. In this work, a numerical optimisation of the unified specimen's fracture toughness components, comprising the combined mode I (modified double cantilever beam) and II (end-loaded split) test, was performed. This was achieved by computing the desired behaviour as a function of the apparatus' and specimens' geometries, through several dimensional parameters, and by testing different adhesives, widening the range of applications of this tool. In the end, a custom data reduction scheme was deduced and set of design guidelines was defined.