Adaptation of the o-DGT for the sampling of 12 hormones: calibration, performance evaluation, and recommendation

This work highlights the methodology for the development of diffusive gradients in thin films (o-DGT) through its adaptation for 12 natural and synthetic hormones belonging to three different families (estrogens, progestins, and androgens). A reliable strategy must be applied during o-DGT lab adaptation to avoid issues related to the analysis (i.e., presence of matrix effects in grab or passive samples) but also to the o-DGT configuration (i.e., undesirable sorption or desorption, lack of performance with insufficient elution or unreliable diffusion coefficient). To avoid analytical issues due to the presence of salts in grab samples, CaCl₂ exposure solutions must be used on a lab-scale development to monitor the hormone concentration. The selected o-DGT was composed of an Oasis® HLB binding gel and a diffusive gel in agarose because they provided better performance than polyacrylamide gels (i.e., higher elution factors and more repeatable diffusion coefficients). The elution factors of the binding gel were then from 0.79 ± 0.13 to 1.04 ± 0.13 (RSD < 15%) and the diffusion coefficients at 25 °C were from 4.07 ± 0.24 to 5.49 ± 0.28 × 10^-6 cm² s^-1 (RSD < 9%). A laboratory exposure to a synthetic solution was performed to check the consistency with the DGT quantification model validating the calibration parameters for all hormones (except 17α-ethinylestradiol with a bias of 40%). Therefore, the o-DGT configuration is suitable for sampling hormones in the natural environment with LOQ_DGT ranging from 0.3 to 6.6 ng L^-1.