Related Experiment Video
Updated: Jul 31, 2025
Minimally Invasive Treatment for Thoracolumbar Burst Fracture Using Sagittal Alignment Screws and A Trauma Reduction Device
Published on: November 8, 2024
Biomechanical Effects of Facet Joint Violation After Single-Level Lumbar Fusion With Transpedicular Screw and Rod
Piyanat Wangsawatwong1, Bernardo de Andrada Pereira, Jennifer N Lehrman
1Department of Neurosurgery, Barrow Neurological Institute, St. Joseph's Hospital and Medical Center, Phoenix, AZ.
Study Design:
In vitro biomechanical study.
Objective:
This study aimed to investigate the biomechanical effects of facet joint violation (FV) on mobility and optically tracked intervertebral disc (IVD) surface strains at the upper level adjacent to L4-5 pedicle screw-rod fixation.
Summary Of Background Data:
FV is a complication that can occur when placing lumbar pedicle screws; the reported incidence is as high as 50%. However, little is known about how FV affects superior adjacent-level spinal stability, and especially IVD strain, after lumbar fusion.
Methods:
Fourteen cadaveric L3-S1 specimens underwent L4-5 pedicle-rod fixation, 7 in the facet joint preservation (FP) group and 7 in the FV group. Specimens were tested multidirectionally under pure moment loading (7.5 Nm). Colored maps of maximum (ε1) and minimum (ε2) principal surface strain changes on the lateral L3-4 disc were generated, with the surface divided into 4 quarters anterior to posterior (Q1, Q2, Q3, and Q4, respectively) for subregional analyses. Range of motion (ROM) and IVD strain were normalized to intact upper adjacent-level and compared between the groups using analysis of variance. Statistical significance was set at P <0.05.
Results:
Normalized ROM was significantly greater with FV vs. FP in flexion (11% greater; P =0.04), right lateral bending (16% greater; P =0.03), and right axial rotation (23% greater; P =0.04). Normalized L3-4 IVD ε1 during right lateral bending was greater on average for the FV group than the FP group: Q1, 18% greater; Q2, 12% greater; Q3, 40% greater ( P <0.001); Q4, 9% greater. Normalized ε2 values during left axial rotation were greater in the FV group, the highest increase being 25% in Q3 ( P =0.02).
Conclusions:
Facet joint violation during single-level pedicle screw-rod fixation was associated with increased superior adjacent level mobility and alteration of disc surface strains, with significant increases in selected regions and directions of loading.
