Related Experiment Video
Updated: Jul 30, 2025

Author Spotlight: Exploring Tea Aroma Using Solvent-Assisted Flavor Evaporation Technique
Published on: May 26, 2023
Erosive potential of ice tea beverages and kombuchas
Elisa Lind1, Hilma Mähönen1, Rose-Marie Latonen2
1Institute of Dentistry, University of Turku, Turku, Finland.
Objectives:
Kombuchas and other tea-based beverages are often perceived as healthy products despite the lack of knowledge on their effects on oral health. This in vitro study determined the erosive potential of commercial kombuchas, and ice teas compared to cola drinks.
Materials And Methods:
The pH and fluoride content of 7 kombuchas and 18 tea drinks were measured with ion-selective electrodes. Calcium dissolution from hydroxyapatite grains was quantified by atomic absorption spectroscopy after beverage exposure. The effect of beverages on the enamel surface was visualized by scanning electron microscopy (SEM). Distilled water, and cola drinks were used as negative and positive controls.
Results:
The kombuchas exhibited lower pH values (2.82-3.66) than the ice teas (2.94-4.86), but still higher than the cola drinks (2.48-2.54). The fluoride concentration varied between 0.05 and 0.46 ppm and for 7 beverages the concentration was below the detection limit. The calcium release for kombuchas was 198-746 mg/l, for ice teas 16.1-507 mg/l, and for cola drinks 57.7-71.9 mg/l. Twenty-two beverages had a significantly greater calcium release than the cola drinks (p = .009-.014). The surface etching of the enamel was seen in the SEM analysis after beverage exposure.
Conclusions:
Tea-based beverages have even higher erosive potential than cola drinks. Kombuchas especially, displayed a considerable erosive potential.
Related Concept Videos
Solvating Effects
Strength and Heat of Hydration
The heat of hydration for each cement compound is significant; for instance, tricalcium aluminate (C3A) and...
Ionic Strength: Effects on Chemical Equilibria
In this solution, the primary...
Weak Acid Solutions
Freezing Point Depression and Boiling Point Elevation
The boiling point of a liquid is the temperature at which its vapor pressure is equal to ambient atmospheric pressure. Since the vapor pressure of a solution is lowered due to the presence of nonvolatile solutes, it stands to reason that the solution’s boiling point will subsequently be increased. Vapor pressure increases with temperature, and so a solution will require a higher temperature than will pure solvent to achieve any given vapor pressure, including one...
Physical Properties Affecting Solubility
As for any solution, the solubility of a gas in a liquid is affected by the attractive intermolecular forces between solute and solvent species. Unlike solid and liquid solutes, however, there is no solute-solute intermolecular attraction to overcome when a gaseous solute dissolves in a liquid solvent since the atoms or molecules comprising a gas are far separated and experience negligible interactions. Consequently, solute-solvent interactions are the sole...

