Related Experiment Video
Updated: Jul 30, 2025

Minimally Invasive Treatment for Thoracolumbar Burst Fracture Using Sagittal Alignment Screws and A Trauma Reduction Device
Published on: November 8, 2024
Sella turcica variations in patients with transverse skeletal discrepancies versus patients with normal transverse
Nouran Seifeldin1, Ahmed Eltimamy2, Nora Al Abbady3
1Department of Orthodontics, Faculty of Dentistry, Cairo University, Giza, Egypt. nouran.fouad@dentistry.cu.edu.eg.
Background:
The sella turcica (ST) is a crucial landmark in orthodontics. It is utilized as a reliable predictor of future growth of the skeletal pattern, assisting in early diagnosis and promoting better treatment planning options. The goal of this research was to compare the morphology and bridging of the sella turcica in transverse maxillary deficient malocclusions and malocclusions with normal transverse relationships.
Methods:
A total of 52 cone beam computed tomographic (CBCT) images were selected with an age range of 18-30 years. Group I comprised 26 patients previously diagnosed with transverse maxillary deficiency, while group II comprised 26 patients with normal transverse skeletal relationships. The length, depth and diameter of the ST were measured by two observers, the shape was evaluated as round, oval or flat and sellar bridging was calculated in each case. An Independent t-test was used to compare between the sellar dimensions in both groups. For assessment of bridging percentage Chi square test was used.
Results:
The mean values of the length, depth and diameter of the sella in group I was 11.09 mm, 8.56 and 12.81 mm respectively and 10.34 mm, 8.24 and 12.38 mm in group II respectively (P ≤ 0.05). No significant differences were found between both groups in any of the sellar dimensions. The rounded ST shape was the most prevalent among both groups (59.6%). Partial ST bridging was found in only 7.7% of group I (p < 0.0001*). Complete ST bridging wasn't detected in either of the groups.
Conclusions:
There was no correlation found between transverse maxillary deficiency and the morphology and bridging of the sella turcica.
Related Concept Videos
Sutures of the Skull
Sutures are immobile joints between adjacent bones of the skull. The narrow gap between the bones is filled with dense, fibrous connective tissue that unites the bones. The long sutures located between the skull bones are not straight but instead follow irregular, tightly twisting paths. These twisting lines tightly...
Vertebral Column: Regions and Curvature
Regions of the Vertebral Column
In an adult, the spine is subdivided into five regions: the cervical, the thoracic, the lumbar, the sacral, and the coccygeal region. The spine initially develops as a series of 33 vertebrae; after 20 years of age, the nine bones in the sacral region, five sacral, and four coccygeal bones fuse to form...
Deformations in a Transverse Cross Section
As the material stretches, it expands or contracts in orthogonal directions to the load. This phenomenon varies...

