An Evaluation Study of a New Designed Oscillating Hydraulic Trainer of Neck

In view of the importance of neck strength training and the lack of adequate training equipment, this study designed a new oscillating hydraulic trainer (OHT) of neck based on oscillating hydraulic damper. We used surface electromyography (sEMG) and subjective ratings to evaluate the neck OHT and compared the results with a simple hat trainer (HATT) and traditional weight trainer (TWT) to verify the feasibility and validity of the OHT. Under similar exercise conditions, 12 subjects performed a set of neck flexion and extension exercise with these 3 trainers. The sEMG signals of targeted muscles were collected in real time, and subjects were asked to complete subjective evaluations of product usability after exercise. The results showed that the root mean square (RMS%) of sEMG indicated that the OHT could provide two-way resistance and train the flexors and extensors simultaneously. The overall degree of muscle activation with OHT was higher than that with the other two trainers in one movement cycle. In terms of resistance characteristics exhibited by the sEMG waveform, duration (D) with OHT was significantly longer than HATT and TWT when exercising at a high speed, while Peak Timing (PT) was later. The ratings of product usability and performing usability of OHT were remarkably higher than that of HATT and TWT. Based on the above results, the OHT was proved to be more suitable for strength training, such as neck muscles, which were getting more attention gradually, but lacked mature and special training equipment.