Lighting Up at High Potential: Effects of Voltage and Emitter Size in Nanoelectrospray Ionization

Effects of electrospray voltage on cluster size and abundance formed from aqueous CsI were investigated with emitter tip diameters between 260 ± 7 nm and 2.45 ± 0.30 μm. Cluster size increases with increasing voltage, increasing solution concentration and increasing emitter diameter consistent with formation of larger initial droplet sizes. For emitters with tip diameters above ∼1 μm, varying the voltage either up or down leads to reproducible voltage-dependent extents of cluster formation. In contrast, higher voltages with submicron diameter emitters can lead to only Cs⁺ and Cs(H₂O)⁺ and no clusters. This change in ion formation reproducibly occurs at spray potentials >1.3 kV for 260 nm emitters and appears to be induced by a corona discharge and material build-up at the emitter tip. Under conditions where abundant Cs⁺ is observed and no clusters are formed, ions such as K⁺ and Cu¹⁺ are also observed but ions with more negative solvation energies, such as Ba²⁺, are not. Similarly, ions from bradykinin and ubiquitin are observed predischarge but not post discharge. Ions with more positive solvation energies can desorb directly from the air-water interface that is created at the tip of these emitters, whereas ions with more negative solvation energies as well as peptide and protein ions do not. These results indicate that ion desorption directly from solution can occur, and similar experiments with even smaller emitters may lead to new insights into ion formation in electrospray ionization.