Related Experiment Video
Updated: Jul 28, 2025
The Transition to an Anterior-Based Muscle Sparing Approach Improves Early Postoperative Function but is Associated with a Learning Curve
Published on: September 7, 2022
Evaluation of anterior translation in total knee arthroplasty utilizing stress radiographs
Sean P Ryan1, Niall H Cochrane2, William A Jiranek2
1Duke University, Durham, USA. sean.p.ryan@duke.edu.
Background:
Flexion instability is a common cause for revision after total knee arthroplasty (TKA); however, little objective criteria exist to determine excessive laxity in flexion. This study sought to determine the reliability of stress radiographs for flexion laxity using manual stress as well as a commercially available flexion stress device, with the hypothesis that a commercially available force device would provide increased translation compared to manual stress, and radiographic measurements would be reproducible.
Methods:
Ten patients who previously underwent TKA with non-hinged components were prospectively and consecutively enrolled at a single center to undergo stress radiographs. Three lateral radiographs with the knee at 90° of flexion were obtained for each patient: rest, commercial stress device at 150N, and manual stress. Calibrated radiographs were evaluated by two raters, and inter-rater and intra-rater reliability were determined using intraclass correlation coefficients (ICC).
Results:
Ten patients (seven female) with mean age 72 (range 55-82) years and average duration from surgery 36 (range 12-96) months were evaluated. The commercial stress device provided significantly less anterior translation than manual stress (- 0.3 mm vs. 3.9 mm; p < 0.01). Two patients reported pain with use of the stress device. Inter-observer reliability of measurements was good for commercial stress (ICC = 0.86) and excellent for manual stress (ICC = 0.94). Eighty-five percent of measurements were within 1 mm between observers. Intra-observer reliability of measurements was good to excellent for both the stress device and manual stress.
Conclusions:
Lateral stress radiographs may assist in the objective evaluation of flexion instability. A commercially available product provided less translation than manual stress; however, measurements were reliable and reproducible between observers. Further research is required to correlate translation with stress radiographs to patient outcomes following revision arthroplasty.
