Pharmaceutical 3D-printing of nanoemulsified eucalypt extracts and their antimicrobial activity

Overcoming the health threatening consequences of staphylococcal infections and their negative socio-economic effects have become a priority in the medical, pharmaceutical, food and many other sectors globally. Staphylococcal infections are a big challenge for a global health care, since they are difficult to be diagnosed and treated. Therefore, the development of new medicinal products of plant-origin is timely and important, because bacteria have a limited ability to develop resistance to such products. In the present study, a modified eucalypt (Eucalyptus viminalis L.) extract was prepared and further enhanced by using different excipients (surface active agents) to obtain a water-miscible 3D-printable extract (nanoemulsified aqueous eucalypt extract). Phytochemical and antibacterial studies of the eucalypt leaves extracts were conducted as a preliminary investigation for 3D-printing experiments of the extracts. The nanoemulsified aqueous eucalypt extract was mixed with polyethylene oxide (PEO) to form a gel applicable for semi-solid extrusion (SSE) 3D printing. The key process parameters in a 3D-printing process were identified and verified. The printing quality of the 3D-lattice type eucalypt extract preparations was very good, demonstrating the feasibility of using an aqueous gel in SSE 3D printing also exhibiting compatibility of the carrier polymer (PEO) with the plant extract. The SSE 3D-printed eucalypt extract preparations presented a rapid dissolution in water within 10-15 min, suggesting the applicability of these preparations e.g., in oral immediate-release applications.