Frequency dependent impedance response analysis of nanocrystalline ZnO chemiresistors

ZnO is a widely studied gas sensor material and is used in many commercial sensor devices. However, selectivity towards any particular gas remains an issue due to lack of complete knowledge of the gas sensing mechanism of oxide surfaces. In this paper, we have studied the frequency dependent gas sensor response of ZnO nanoparticles of a diameter of nearly 30 nm. A small rise of synthesis temperature from 85 °C to 95 °C in the solvothermal process, shows coarsening by joining and thereby distinct loss of grain boundaries as seen from transmission electron micrographs. This leads to a substantial reduction in impedance, Z (GΩ to MΩ), and rises in resonance frequencyfres(from 1 to 10 Hz) at room temperature. From temperature dependent studies it is observed that the grain boundaries show a Correlated Barrier Hopping mechanism of transport and the hopping range in the grain boundary region is typically 1 nm with a hopping energy of 153 meV. On the other hand, within the grain, it shows a change of transport type from low temperature tunneling to beyond 300 °C as polaron hopping. The presence of disorder (defects) as the hopping sites. The temperature dependence offresagrees with different predicted oxygen chemisorbed species between 200 °C to 400 °C. As opposed to the traditional DC response, the AC response in the imaginary part of (Z″) shows gas specific resonance frequencies for each gas, such as NO2, ethanol, and H2. Among the two reducing gases, ethanol and hydrogen; the former shows good dependence on concentration in Z″ whereas the latter shows a good response infresas well as capacitance. Thus, the results of frequency dependent response allow us to investigate greater details of the gas sensing mechanism in ZnO, which may be exploited for selective gas sensing.